1. In an effort decide your files, DIY data recovery if the risk is very important. They are very important if you decide to risk your files, a flash drive to a data recovery company to find out.
These tools are designed specifically for fixing hardware and circuit cards. The most advanced companies to extract and decode the raw data stored in the NAND chip from the circuit board in order to remove the tools.
$ 850 depending on the severity of the damage to the unit and the necessary recovery - data recovery can cost up to $ 20. Some of the smaller companies that spend less than $ 200 body internal / data recovery solutions offer moderate damage.
2. Getting tools. If you decide to be comfortable risking your files, you need to:
Flux welding and welding
An old USB cable
Wire cutter / strippers
A small flat head screwdriver
A magnifying glass or jeweler's loop to
Note: Your flash drive is a broken link, these guidelines apply only.
3. Using flat head screwdriver, carefully remove the outer shell of the flash drive.
4. Circuit (PCB) and use the magnifying glass to inspect the solder points. The PCB itself is damaged or solder points are highlighted, you may need the help of a professional.
Note: the solder pads on the circuit board solder copper lines that connect the USB connector contacts are 4 bits. If the connection has come off without damaging the PCB points or welding, continue to the next step. You can end the connection to the solder pads on a flash drive on a hard surface 5Adjust.
5. Use wire cutters to cut off the end of the 6 USB cable. If the woman is not in the final cut man.
6. Each of the four wires from the interior of the cable is about 0.25 inches (0.6 cm) to expose a stripper 7Use. Or, if you are not free to use the USB cable, you have broken the USB connector pins on each of the pieces of small gauge wire, can bind; This will create their own mini-USB cable.
7.Each of the four points, four wires for welding Weld 8. From left to right colors, black, green, white, red are available. From left to cut away the two boxes, USB while holding the right, the array must be connected to the solder points. The up or flash (and files) Do not mix the unit is toast.
8.If you use cables instead of a cable for your own personal, just regardless of what color wire, solder wire for each person on your site.
9 At the other end of the USB cable to connect a computer to cross your fingers.
If you register, great! Store the files on your computer.
It is still not recognized, it is not just a problem for those who are likely to have a different background. Or consider sending a business professional, or you can always restore your important files, you are prompted to re-use as a Christmas tree ornament.
0 comments:
Post a Comment